本文主要從技術層面向大家介紹了如何通過手動去調整路由器Buffer的分配,那麽我們在配置時要進行哪些操作呢?此文會對妳有所幫助。
路由器維護兩個 Buffer池,public buffers和 interface buffers
調整public buffers
Router1#configure terminal
Enter configuration commands, one per line.End with CNTL/Z.
Router1(config)#buffers big initial 100
Router1(config)#buffers big max-free 200
Router1(config)#buffers big min-free 50
Router1(config)#buffers big permanent 50
Router1(config)#end
Router1#
調整interface buffers
Router1#configure terminal
Enter configuration commands, one per line.End with CNTL/Z.
Router1(config)#buffers Ethernet0 initial 200
Router1(config)#buffers Ethernet0 max-free 300
Router1(config)#buffers Ethernet0 min-free 50
Router1(config)#buffers Ethernet0 permanent 50
Router1(config)#end
Router1#